Plug for profile 30x60, hole 8 mm

End cap for modular profiles

This end cap is suitable for all 30x60 mm profiles with a centre hole of 7.5 - 8 mm.

The end cap has an 8 mm wide "peg" - it is therefore necessary to install in profiles with an 8 mm groove, or to cut the peg before installation.

Installation:

• Pin the plug to the profile hole and align the sides with the side of the profile.
• Press it in as deep as you can with your hand
• Tap the profile against a firm, smooth surface, or tap it with a rubber mallet
• to push the end of the profile to the stop.

Parameters:

• Size: 30x60 mm
• Pin length: 8 mm
• Thickness of the "pancake" end: 4 mm

Compatibility:

• The tip is compatible with any 30x60 mm profile, and a center hole of 7.5 - 8 mm
  
• We only guarantee compatibility with the 3060 profile, 8 mm groove, which we offer