The non-stick layer on the nozzle guarantees trouble-free printing of even more complex materials More
Improved MK8 nozzle coated with a non-stick Teflon layer
Compatible with Ender and CR and hotends MK8 / CR10.
A brass nozzle that all printers will appreciate. The non-stick layer prevents the formation of blobs, precisely because blobs are formed during printing on the lower part of the nozzle so that the material is gradually packed on it.
When such a blob then acquires and falls from the nozzle into the printout, it causes a layer-shift, an ugly surface, or another undesirable problem.
Another advantage is that the nozzle remains clean for a much longer time. So you don't have to "burn nozzle with hell-flame" every now and then. :)
Nozzles with a Teflon layer are available in the following sizes:
0.2 mm
0.3 mm
0.4 mm
0.5 mm
0.6 mm
0.8 mm
1.0 mm
Everyone chooses their Teflon nozzle.
A N
Positives+
Positives+
Negatives-
Negatives-
Petr Florián
PositivesZatím netestováno.
PositivesZatím netestováno.
Negatives
Negatives
Miki
Positivesfunguje správně
Positivesfunguje správně
Negatives
Negatives
Milan Růžička
PositivesPrvních pár tisků bomba, fialment absolutně neulpíval na trysce.
PositivesPrvních pár tisků bomba, fialment absolutně neulpíval na trysce.
NegativesPo několika tiscích se teflonová vrstvy postupně odlupuje, životnost není moc dobrá, ale i tak je to lepší než obyč mosaz
NegativesPo několika tiscích se teflonová vrstvy postupně odlupuje, životnost není moc dobrá, ale i tak je to lepší než obyč mosaz
Lukáš Králík
PositivesOk
PositivesOk
NegativesNic
NegativesNic