Accesorries - Size - 180mm/75mm
How to use HARZ Labs UV resin for casting
Recommended procedure for firing Dental Cast Cherry resin. You should follow these recommendations when creating a model for printing.
HARZ Labs resin postprocessing
HARZLabs Psyresin Correct Post-Process Chart.
Proper post-processing of HARZ Labs resin is key to the properties of the printed model. You can learn how to print resin HERE. Curing time depends on the type of resin. For modeling resins, we recommend curing for 10-30 minutes. It is enough that the surface does not stick and the model hardens. To achieve maximum toughness and hardness, the dental resins must be fully cured, a time of 30-60 minutes is recommended.
Print settings for (not only) Harzlabs resins
There is a whole range of stereolithography 3D printers. Therefore, we cannot provide specific recommendations for print modes. So this page contains general tips for setting up 3D printers to work with HARZ Labs resins. The page is divided into several sections, and each section will vary from printer to printer (for example, depending on the strength of the UV source or the thickness of the FEP film).
Setting up the Formlabs Form2 printer for HARZ Labs resins
Simple Formlabs printer setup chart for HARZ Labs resin tosk. Offer of resins for FORM printers under the link here >>.